ALTF 2 RS485 incl. cable tie
Contact temperature sensor/pipe contact sensor with RS485 output
Application
The ALTF 2 RS485 is a pipe contact temperature sensor in IP65 housing with quick-locking screw whose signal communicates via RS485 Modbus®-RTU and S-Bus. For recording the temperature by means of surface measurement on pipes (e.g. cold and hot water) or on heating lines for heating control.
Technical Data
| Measuring range: | - 30 ...+110 °C |
| Power supply: | 24V DC ± 20% |
| Power consumption idle: | 15mA |
| Bus protocol: | RS485 Modbus®-RTU / S-Bus |
| Configuration option: | via Dip switches (address number, parity, Baud) |
| Address number: | 1 bis 63 (0 not allowed) |
| Parity mode for Modbus: | no parity, even parity, odd parity |
| Saia S-Bus: | Data Mode |
| Transmission rate: | 4800, 9600, 19200, 38400 Baud |
| Inputs: | PT1000 1/3 DIN (24 bit resolution / 0,1°C) |
| Ambient temperature: | -30°C...+60°C |
| Storage temperature: | -40°C...+70°C |
| Accuracy: | < 0,1% for temperature measurement PT1000 |
| Temperature coefficient: | < 0,003% / K for temperature measurement PT1000 |
| Process connection: | Cable tie made of plastic (included) |
| Cable tie dimensions: | Ø = 13 - 61 mm (1⁄4 - 2“) 180mm |
| Connection head: | made of plastic, polyamide, 30% glass bead reinforced with quick-release colour pure white (similar to RAL 9010) |
| Dimensions: | 70 x 62 x 37 mm |
| Electrical connection: | bis 2,5 mm² via double push-in terminals |
| Cable gland: | 1 oder 2 x M16, with strain relief |
| Insulation resistance: | ≥ 100 MΩ, at 20 °C (500V DC) |
| Humidity: | < 95 % r. H., non-condensing air |
| Protection class: | III (according to EN 60 730) |
| Protection type: | IP 54 (according to IEC 529) |
| Normen: | CE conformity |
| EMC: | according to EN55011 class B |
